Mitsubishi Electric MELSEC-Q Series User Manual page 815

Ethernet cable
Category 5e or higher
(Double shielded/STP) Straight cable
POINT
When using linear servo motor control mode, direct drive motor control mode and
fully closed loop control mode, set the followings.
Operation mode
Linear servo motor • Set "4: Linear servo motor control mode" in the "operation mode selection"
control mode
Direct drive motor • Set "6: DD motor control mode" in the "operation mode selection" of the
control mode
• Set "1: Fully closed loop control mode" in the "operation mode selection" of
Fully closed loop
• Set "1: Fully closed loop control" in "[Cd.133] Semi/Fully closed loop
control mode
For wiring the CC-Link IE Field Network cable, use the 1000BASE-T compliant
Ethernet cables.
RJ-45 connector
POINT
• For CC-Link IE Field Network wiring, use the recommended wiring components
by CC-Link Partner Association.
• Cables for CC-Link IE Controller Network cannot be used for CC-Link IE Field
Network.
of the servo parameter "Operation mode (PA01)".
servo parameter "Operation mode (PA01)".
the servo parameter "Operation mode (PA01)".
switching request". The switching status of semi closed loop control/fully
closed loop control is indicated in "[Md.113] Semi/Fully closed loop status".
Connector
The following conditioning cables:
• IEEE802.3 (10000BASE-T)
• ANSI/TIA/EIA-568-B (Category 5e)
Appendix - 15
Setting
Type
Appendices