Mitsubishi Electric MELSEC-Q Series User Manual page 370

(8) Reading data from buffer memory/internal memory to GX Works2
( )
The following transmission processes are carried out with the [Read from module
(Read from QD77GF)] from the GX Works2.
1) The "parameters", "positioning data (No. 1 to 600)", "block start data (No.
7000 to 7004)" and "servo parameter (MR-J4-B use)" in the buffer
memory/internal memory area are transmitted to the GX Works2 via the PLC
CPU.
The following transmission processes are carried out with the [monitor] from the
GX Works2.
2) The "monitor data" in the buffer memory area is transmitted to the GX Works2
via the PLC CPU.
(9) Writing data from GX Works2 to buffer memory/internal memory
( )
The following transmission processes are carried out with the [Write to module
(Write to QD77GF)] from the GX Works2.
1) The "parameters", "positioning data (No. 1 to 600)", "block start data (No.
7000 to 7004)" and "servo parameter (MR-J4-B use)" in the GX Works2 are
transmitted to the buffer memory/internal memory via the PLC CPU.
At this time, when [Flash ROM automatic write] is set with the GX Works2, the
transmission processes indicated with "(7) Writing the flash ROM by a GX
Works2 request" are carried out.
Chapter 7 Memory Configuration and Data Process
7 - 12