Mitsubishi Electric MELSEC-Q Series User Manual page 771

Related buffer memory address
29+150n
Same as error codes 515 to 516
Refer to Section 5.3
"List of positioning data"
Same as in error codes 525 to 526.
Set range
(Setting with sequence program)
<Interpolation speed designation method>
0: Composite speed
1: Reference axis speed
<Positioning address/movement amount>
• Unit [mm] [PLS] [inch]
–2147483648 to 2147483647
(Unit [degree]) cannot be set.
<Arc address>
–2147483648 to 2147483647
16 - 25
Chapter 16 Troubleshooting
Remedy
Set the "Interpolation speed designation method" correctly.
(Refer to Section 9.1.6)
Correct the control method, axis to be interpolated or
parameter.
(Refer to Section 9.1.6, 9.2.20)
Correct the sub address (arc address).
(Refer to Section 9.2.10)
Correct the end address (positioning address).
(Refer to Section 9.2.10)
Correct the center point address (arc address).
(Refer to Section 9.2.11)
n: Axis No.-1