Mitsubishi Electric MELSEC-Q Series User Manual page 256

Setting item
[Cd.7] M code OFF request
[Cd.8] External command valid
[Cd.9] New current value
[Cd.10] New acceleration time value
[Cd.11] New deceleration time value

The M code ON signal turns OFF.
Fetch cycle: Operation cycle

Validates or invalidates external command signals.
Fetch cycle: At request by external command signal

When changing the "feed current value" using the start No. "9003", use this data
item to specify a new feed value.

The setting value range differs according to the "[Pr.1] Unit setting".
mm
[Pr.1] Unit
(  10 -1
setting µm)
-2147483648
Setting range to
2147483647
Fetch cycle: At change request

When changing the acceleration time during a speed change, use this data item
to specify a new acceleration time.
[Cd.10] setting range (unit)
0 to 8388608 (ms)
Fetch cycle: At change request

When changing the deceleration time during a speed change, use this data item
to specify a new deceleration time.
[Cd.11] setting range (unit)
0 to 8388608 (ms)
Fetch cycle: At change request
5 - 136
Chapter 5 Data Used for Positioning Control
Setting details
inch degree
(  10 -5 (  10 -5
inch) degree)
-2147483648
to 0 to 35999999
2147483647
PLS
(PLS)
-2147483648
to
2147483647