Mitsubishi Electric MELSEC-Q Series User Manual page 637

Control type
Machine HPR control
HPR control
Fast HPR control
Position
control
Major
positioning
control
1 to 4-axes speed control
Speed-position switching control
Position-speed switching control
Other
control
JOG operation, Inching operation
Manual
control
Manual pulse generator operation
Expansion
Speed-torque control
control
: Check valid
: Check is not made when the feed current value is not updated (Refer to [Pr.21]) at the setting of "feed current value"
in "[Pr.14] Software stroke limit selection" during speed control.
– : Check not carried out (check invalid).
: Valid only when "0: valid" is set in the "[Pr.15] Software stroke limit valid/invalid setting".
1 : The value in "[Md.20] Feed current value" will differ according to the "[Pr.21] Feed current value during speed
control" setting.
2 : When the unit is "degree", check is not made during speed control.
3 : When the unit is "degree", check is not carried out.
[3] Relation between the software stroke limit function and various
controls
Data set method
Other than "Data
set method"
1-axis linear control
2 to 4-axes axis linear
interpolation control
1-axis fixed-feed control
2 to 4-axes fixed-feed control
(interpolation)
2-axis circular interpolation
control
Current value changing
JUMP instruction, NOP
instruction, LOOP to LEND
Limit
check
The HPR control will not be executed if the HP address
is outside the software stroke limit range.
–
Check not carried out.
–
Checks 1) and 2) in the previous section [2] are carried
out.
For speed control: The axis decelerates to a stop
For position control: The axis comes to an immediate
*1, *2
*1, *2
The current value will not be changed if the new
current value is outside the software stroke limit range.
– Check not carried out.
Check 1) in the previous section [2] is carried out.
* 3
The machine will carry out a deceleration stop when
the software stroke limit range is exceeded. If the
address is outside the software stroke limit range, the
* 3
operation can only be started toward the moveable
range.
Check 1) in the previous section [2] is carried out.
The mode switches to the position control mode when
the software stroke limit range is exceeded, and the
operation immediately stops.
13 - 33
Chapter 13 Control Sub Functions
Processing at check
when it exceeds the software
stroke limit range.
stop when it exceeds the software
stroke limit range.