Mitsubishi Electric MELSEC-Q Series User Manual page 740

Setting value
0 Feed current value
1 Feed machine value
2 Real current value
3 Servo input axis current value
6 Synchronous encoder axis current value
Synchronous encoder axis current value
7
per cycle
Current value after composite main
8
shaft gear
Current value per cycle after main shaft
9
gear
Current value per cycle after auxiliary
10
shaft gear
11 Cam axis current value per cycle
Cam axis current value per cycle (Real
12
(Note)
position)
[Pr.803] Mark detection data axis No.
Set the axis No. of data that latched at mark detection.
[Pr.802] Mark detection data type
Data name
(Note): Cam axis current value per cycle that considered delay of the servo system.
If a value other than the above is set, the warning "Outside mark detection data
axis No. setting range" (warning code: 132) occurs and the target mark detection
is not available.
[Pr.804] Mark detection data buffer memory No.
Set the No. of optional 2 words buffer memory that latched at mark detection.
Set this No. as an even No.
If a value other than the above is set, the warning "Outside mark detection data
buffer memory No. setting range" (warning code: 133) occurs and the target mark
detection is not available.
Unit
-1 -5
10 [µm], 10 [inch],
-5
10 [degree], [PLS]
Synchronous encoder
axis position unit
Main input axis position
unit
Cam axis cycle unit
14 - 28
Chapter 14 Common Functions
[Pr.803] Mark detection data axis No.
QD77GF4 QD77GF8 QD77GF16
1 to 4 1 to 8
801 to 804
1 to 4 1 to 8
1 to 16
1 to 16