NorthStar 961X Operation And Reference Manual page 250

Chapter 12 - Alarms, TideTrack, and Currents
Name of alarm
CLOSE TO _____
ARRIVE AT _____
PASSING _____
CHANGING TO _____
AVOID _____!
AVOID ____ IN TRIP
Page 12-4
2. To clear the alarm message from the screen and stop the
alarm audio (if on), press the CLEAR ALARM key.
The 961 moves the new alarm to the OLD ALARMS box.
For a description of auto-clearing alarms and ones that require
manual clearing, see "Table 8: 961 alarms" below.
Table 8: 961 alarms
Description
This alarms means you're within .15 nauti-
cal miles of entering the active waypoint's
arrival radius. You can set the arrival
ALARMS
radius at the
This alarm means you've entered the
active waypoint's arrival radius
wait until the alarm automatically clears, or
you can manually clear the alarm by
CLEAR ALARM
pressing the
ALARMS
screen. The factory setting for
the arrival radius field is 0.02 nm, or
approximately 120 feet. You can com-
pletely disable this alarm; see "Changing
alarm settings" starting on page 12-6.
This alarm means you've passed abeam
of the active waypoint (only appears when
there are no future waypoints, or when in
MOB mode, or during manual sequenc-
ing).
This alarm means you're switching to your
trip's next leg.
This alarm means you've entered an
avoidance point.
This alarm means you're on a direct
course line to an avoidance point.
screen.
.
You can
key at the
961 Operations and Reference Manual Rev. D
Auto clear (yes/no)
Yes, after five seconds.
Yes, when leaving the
arrival radius, or by
passing the active way-
point, or by changing to
a new one.
Yes, after five seconds.
Yes, after five seconds.
No, you must manually
clear the alarm.
No, you must manually
clear the alarm.