Table of Contents
Advertisement
961 Operations and Reference Manual Rev. D
5. Press the GO NOW key.
The JOIN LEG dialog box appears, prompting you to
remember to press the SAVE key at the point where you
actually join the leg (a SAVE keypress will store that point
in the trip).
6. Press the OK key.
The 961 begins navigating along the selected route leg,
then follows the rest of the route.
Adding a route to the end of your trip
You can add an entire route, or only part of a route, to the end
of your trip.
1. On the ROUTES screen, press the CURSOR PAD up or
down to select the desired route.
2. To display the route on the CHART screen, press the ON
CHART key, then press the CHART key.
3. On the CHART screen, press the CURSOR PAD to select
the starting point or starting leg of the route.
The name of the selected route must appear in the CUR-
SOR INFO BAR at the bottom of the screen; if necessary,
press the LEFT ARROW and RIGHT ARROW keys. To
add the entire route, select POINT 1 of the desired route;
to add only part of the route, select the desired POINT
and the 961 will add the route starting at this point. You
also can select a route leg, and the 961 will add the route
starting at the beginning point of the selected leg, includ-
ing all subsequent legs and points.
4. Press the CURSOR menu key.
The SELECTED ROUTE LEG or SELECTED ROUTE
POINT dialog box appears, depending on whether you
selected a route point or a route leg.
5. Press the ADD TO END OF TRIP key.
The 961 adds the route to the end of your trip. If you were
already past the end of the existing trip, you'll immediately
begin navigating to the new route.
Chapter 10 - Waypoint and Route Navigation
Page 10-13
Advertisement
Table of Contents
