Table of Contents
Advertisement
Chapter 7 - Creating Avoidance Points
Page 7-6
The AVOIDANCE POINTS screen lists all your existing avoid-
ance points, showing radius, name, distance from your present
position, bearing, and lat/lon or TDs and GRI.
To select an avoidance point (indicated by the horizontal
stripe), press the CURSOR PAD up or down.
To the right of the LONGITUDE column is a red vertical slide
bar, which is relative to the size of the list of avoidance points.
The smaller the slider, the larger the list; the larger the slider,
the smaller the list. The slider also indicates your position in
the list, i.e. at the top, in the middle, at the bottom, or any-
where else in between.
The radii of the avoidance points can be displayed in either
yards or in meters, depending upon which distance and speed
units you've selected on the 961's DISPLAY SETUP screen.
The radii of avoidance points can range from 1 to 999 yards or
meters. To display radius in yards (one yard equals 36 inches),
on the DISPLAY SETUP screen, select either MI/MPH or NM/
KTS; to display radius in meters (one meter equals 39.37
inches), always select KM/KPH. Remember: whatever units you
select will affect all of the 961's distance and speed-related dis-
plays.
Avoidance points screen
961 Operations and Reference Manual Rev. D
Advertisement
Table of Contents
