Verifying Services - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
----End

13.3.2.7 Verifying Services

This topic describes how to use the PDH/SDH tester to verify the private line access service.
Prerequisites
The private line service has been configured.
Networking
Figure 13-6 Test setup for E1 upstream service
E1 port
loopback
Issue 01 (2014-04-30)
huawei(config-if-tdm-)#display port state 0
---------------------------------------
Port : 0
State : normal
Mode : UDT
Code : HDB3
Looptype : -
Timeslot : -
Clock : system
CRC4 : -
Signaling : -
ESF : -
Impedance : 120 Ohm
---------------------------------------
3. Query configurations and the status of the system clock source.
Run the display clock source command to query configurations and the status of the
system clock source.
huawei(config-if-tdm-)#quit
huawei(config)#display clock source
---------------------------------------------------------------
Index Config
---------------------------------------------------------------
0 YES
1 NO
2 NO
3 NO
4 NO
5 NO
6 NO
7 NO
8 NO
9 NO
---------------------------------------------------------------
ONU
ONU trace
the clock of
the OLT
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
Type Source State
line 0/0/1 Normal
-- -/ -/ - ---
-- -/ -/ - ---
-- -/ -/ - ---
-- -/ -/ - ---
-- -/ -/ - ---
-- -/ -/ - ---
-- -/ -/ - ---
-- -/ -/ - ---
-- -/ -/ - ---
OLT trace
the clock of
the tester
Priority Output
0 YES
--- ---
--- ---
--- ---
--- ---
--- ---
--- ---
--- ---
--- ---
--- ---
OLT
E1 line tester
E1
Internal
free-run
clock
1296