Configuring Ethernet Access Service Ports On Onus - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide
Add a new traffic profile 10 and set the assured rate to 100 Mbit/s. Packets transmitted upstream
use the priority (4 by default) copied from the user side. Packets transmitted downstream use
the priority carried by themselves.
huawei(config)#traffic table ip index 10 cir 102400 priority user-cos 4 priority-
policy tag-in-package
Step 3 Configure a QinQ service port.
According to
are all translated to CLVAN 300. Then, the OLT adds an SVLAN tag to the packets: CVLAN<-
>SVLAN+CVLAN. Traffic profile 10 is used.
huawei(config)#service-port vlan 1300 gpon 0/3/1 ont 1 gemport 12 multi-service
user-vlan 300 rx-cttr 10 tx-cttr 10
NOTE
If you need to transparently transmit the CVLAN to SVLAN, then user qinq SVLAN, set SVLAN=CVLAN,
and creat a service-port with "tag-transform transparent".
----End

13.3.3.6 Configuring Ethernet Access Service Ports on ONUs

This topic describes how to configure service ports on ONUs and upstream VLANs to make the
connections between ONUs and user terminals reachable and create upstream channels between
ONUs and the OLT, achieving access of IP PBX services through Ethernet ports.
Data Planning
Configuration
Item
Port
SVLAN
Traffic profile
Procedure
Step 1 Remotely log in to an ONU to configure the ONU.
You can remote log in to the ONU from the OLT to perform the configuration. User name:
root (default); password: mduadmin (default)
Issue 01 (2014-04-30)
13.2.2 Principle of VLAN Data
Data
Upstream port: 0/0/1
Service port: 0/3/1
VLAN ID: 300
VLAN type: smart
VLAN attribute: common
Profile ID: 8
Assured rate: no rate limit
Priority source: user-cos
Default priority: 4
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
Plan, VLANs of packets sent from the IP PBX
1305