Nokia 7210 Configuration Manual page 86

CLI Usage
Allowed Values for Port and Encapsulation Types (Continued)
Table 16
Ethernet Dot1q
Ethernet QinQ
interval seconds — Specifies the interval for each display in seconds.
repeat repeat — Specifies how many times the command is repeated.
absolute — Keyword to display the absolute rate-per-second value for each statistic.
rate — Keyword to display the rate per second for each statistic instead of the delta.
sdp
Syntax sdp {sdp-id | far-end ip-address} [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id service-id
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command monitors statistics for a SDP binding associated with this service.
Parameters sdp-id — Specifies the SDP identifier.
absolute — Keyword to display the absolute rate per second value for each statistic.
far-end ip-address — Specifies the system address of the far-end 7210 SAS for the SDP
interval seconds — Specifies the interval for each display, in seconds.
rate — Keyword to display the rate per second for each statistic instead of the delta.
86
0 to 4094
qtag1: 0 to 4094
qtag2: 0 to 4094
Values qtag1: 0 to 4094
qtag2 : * | 0 to 4094
Default 11 seconds
Values 11 to 60
Default 10
Values 1 to 999
Values 1 to 17407
in dotted decimal notation.
Default 11 seconds
Values 11 to 60
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
The SAP is identified by the 802.1Q tag on the port.
A 0 qtag1 value also accepts untagged packets on
the dot1q port.
The SAP is identified by two 802.1Q tags on the
port. A 0 qtag1 value also accepts untagged
packets on the dot1q port.
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA