Nokia 7210 Configuration Manual page 719

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Step 19. At the prompt, enter the URL location of the software image; for example,
Configuration File Location
---------------------------
Config File URL:
Step 20. At the prompt, enter the URL location of the configuration file. The following
Network Configuration
---------------------
Boot Interface Management
-------------------------
Existing eth-mgmt port settings are:
Step 21. At the prompt, enter edit. The following output is displayed.
Enter eth-mgmt Active IP Address :
3HE 17358 AAAB TQZZA
ftp://<user>:<password>@10.10.170.22/./images/both.tim.
The following console output is displayed.
You must enter the location of configuration
file to be used by TiMOS.
a Compact Flash device, a USB flash drive, or
on the network.
Here are some examples
uf1:/config.cfg
cf1:/config.cfg
ftp://user:passwd@192.168.1.150/./config.cfg
ftp://user:passwd@[3FFE::1]/./config.cfg
tftp://192.168.1.150/./config.cfg
tftp://[3FFE::1]/./config.cfg
console output is displayed.
You specified a network location for either the
software or the configuration file. You need to
configure either eth-mgmt or uplinkA or uplinkB ports.
You will be asked to configure the port number, IP(v6) address,
static routes, and VLAN Id in case of uplink ports.
eth-mgmt-port
eth-mgmt-address 0 active
eth-mgmt-address 0 standby
eth-mgmt-address 0 active
eth-mgmt-address 0 standby
eth-mgmt port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
You need to assign an IP address for this port.
The IP address should be entered in standard
dotted decimal form with a network length.
example: 192.168.1.169/24
Use subject to Terms available at: www.nokia.com
The file can be on
© 2021 Nokia.
Appendix: 7210 SAS Boot Procedures
719