Nokia 7210 Configuration Manual page 440

Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs Also See for 7210:
Table of Contents

Advertisement

System Management
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description
This command configures the node to receive broadcast packets on a given subnet.
Broadcast and multicast messages can easily be spoofed, thus, authentication is strongly
recommended. If broadcast is not configured then received NTP broadcast traffic will be
ignored. Use the show command to view the state of the configuration.
The no form of this command removes the address from the configuration.
Parameters
router router-name — Specifies the router name used to receive NTP packets.
interface ip-int-name — Specifies the local interface on which to receive NTP broadcast
authenticate — Specifies whether or not to require authentication of NTP PDUs. When
ntp-server
Syntax
ntp-server [authenticate]
no ntp-server
Context
config>system>time>ntp
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description
This command configures the node to assume the role of an NTP server. Unless the server
command is used, this node will function as an NTP client only and will not distribute the time
to downstream network elements.
Default
no ntp-server
Parameters
authenticate — Keyword to make authentication a requirement. If authentication is
peer
Syntax
peer ip-address [key-id key-id] [version version] [prefer]
no peer ip-address
Context
config>system>time>ntp
440
Values
Base, management
Default
Base
packets, up to 32 characters. If the string contains special characters (#, $, spaces,
and so on), the entire string must be enclosed within double quotes.
enabled, NTP PDUs are authenticated upon receipt.
required, the authentication key ID received in a message must have been
configured in the authentication-key command, and that the key ID type and value
must also match.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7210 sas-mxp7210 r67210 r127210 s7210 sx7210 t

Table of Contents