Nokia 7210 Configuration Manual page 85

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
sap
Syntax sap sap-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>service>id
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command monitors statistics for a SAP associated with this service.
This command displays statistics for a specific SAP, identified by the port-id and
encapsulation value, at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the SAP. The subsequent statistical
information listed for each interval is displayed as a delta to the previous display. When the
keyword rate is specified, the rate per second for each statistic is displayed instead of the
delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of
times at the interval specified.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition.
port-id — Specifies the physical port ID in the slot/mda/port format.
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or
Allowed Values for Port and Encapsulation Types
Table 16
Port Type Encap-Type
Ethernet Null
3HE 17358 AAAB TQZZA
Values sap-id:null[port-id | lag-id]
dot1q [port-id | lag-id]:* | qtag
qinq [port-id | lag-id]:qtag1.qtag2
port-id slot/mda/port
lag-idlag-id
lag keyword
id1 to 200
qtag10 to 4094
qtag2 *, 0 to 4094
dlci 16 to 022
If the card in the slot has Media Dependent Adapters (MDAs) installed, the port-id
must be in the slot_number/MDA_number/port_number format. For example 1/2/3
specifies port 3 on MDA 2 in slot 1.
sub-port. If this parameter is not specifically defined, the default value is 0.
The values depends on the encapsulation type configured for the interface. The
following table describes the allowed values for the port and encapsulation types.
Allowed Values
0
Use subject to Terms available at: www.nokia.com
Comments
The SAP is identified by the port.
© 2021 Nokia.
CLI Usage
85