Nokia 7210 Configuration Manual page 692

Appendix: 7210 SAS Boot Procedures
Press ENTER to begin, or 'flash' to enter firmware update...
Step 5. At the prompt, press Enter to edit the BOF. The following console output is
Chassis-Role
-------------
Current chassis-role is : factory-default
You can change it to { satellite | standalone }.
Press ENTER to continue OR "edit" to change the chassis-role :
Chassis-role is set to factory-default, Do you wish to continue with this (yes/no) :
Step 6. At the prompt, enter yes. The following console output is displayed.
Software Location
-----------------
or Type 'auto' to retrieve BOF configuration through DHCP.
Software Image URL:
Step 7. At the prompt, enter the location of the image.
Configuration File Location
---------------------------
Config File URL:
Step 8. Enter the location of the configuration file, or press Enter to skip this step.
692
displayed.
You must enter the URL of the TiMOS software.
The location can be on a Compact Flash device,
a USB flash drive, or on the network.
Here are some examples
cf1:/timos1.0R1
uf1:/timos1.0R1
ftp://user:passwd@192.168.1.150/./timos1.0R1
ftp://user:passwd@[3FFE::1]/./timos1.0R1
In factory-shipped 7210 SAS devices, the image is typically available at
cf1:\both.tim or cf2:\both.tim.
The following console output is displayed.
You must enter the location of configuration
file to be used by TiMOS.
a Compact Flash device, a USB flash drive, or
on the network.
Here are some examples
uf1:/config.cfg
cf1:/config.cfg
ftp://user:passwd@192.168.1.150/./config.cfg
ftp://user:passwd@[3FFE::1]/./config.cfg
tftp://192.168.1.150/./config.cfg
tftp://[3FFE::1]/./config.cfg
The following console output is displayed.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
The file can be on
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA