Nokia 7210 Configuration Manual page 471

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
ql-override
Syntax ql-override {prs | stu | st2 | tnc | st3e | st3 | sec | prc | ssu-a | ssu-b}
no ql-override
Context config>system>sync-if-timing>ptp
config>system>sync-if-timing>ref1
config>system>sync-if-timing>ref2
config>system>sync-if-timing>bits1
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode; not supported on 7210 SAS platforms
configured in the standalone-VC operating mode
Description
Note:
This command configures the QL value to be used for the reference for SETS input selection
and BITS output. This value overrides any value received by that reference's SSM process.
Default no ql-override
Parameters prs — Specifies the SONET Primary Reference Source Traceable.
stu — Specifies the SONET Synchronous Traceability Unknown.
st2 — Specifies the SONET Stratum 2 Traceable.
tnc — Specifies the SONET Transit Node Clock Traceable.
st3e — Specifies the SONET Stratum 3E Traceable.
st3 — Specifies the SONET Stratum 3 Traceable.
prc — Specifies the SDH Primary Reference Clock Traceable.
ssu-a — Specifies the SDH Primary Level Synchronization Supply Unit Traceable.
ssu-b — Specifies the SDH Second Level Synchronization Supply Unit Traceable.
sec — Specifies the SDH Synchronous Equipment Clock Traceable.
ql-selection
Syntax [no] ql-selection
Context config>system>sync-if-timing
3HE 17358 AAAB TQZZA
• The config>system>sync-if-timing>ptp context is not supported on 7210 SAS-Sx
10/100GE and 7210 SAS-S 1/10GE platforms.
• The config>system>sync-if-timing>bits1 context is not supported on 7210 SAS-Sx
10/100GE, 7210 SAS-S 1/10GE, and 7210 SAS-M platforms.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
471