Nokia 7210 Configuration Manual page 699

Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs Also See for 7210:
Table of Contents

Advertisement

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Step 17. At the prompt, press Enter to proceed existing port settings. The following
Current configuration enables use of console (setting is "no console-disabled")
Press ENTER to proceed with existing setting
:
Step 18. At the prompt, press Enter to proceed with the existing settings. The
New Settings
------------
bcmiproc-both.tim
#uplinkA Port Settings:
#uplinkB Port Settings:
#System Settings:
Do you want to overwrite cf1:/bof.cfg with the new settings? (yes/no):
Step 19. Enter yes to overwrite the bof.cfg file. The 7210 SAS device starts booting.
Successfully saved the new settings in cf1:/bof.cfg
Configuring Network with uplinkA Port Setting.....
Primary config file location: ftp://*:*@192.254.173.5/tmp/dxp/dxp2537.cfg
Initializing uplinkA port using IP addr 10.135.25.37.
Port 1/1/1-->Mode:Fix-Cu, Speed:100, Duplex:Full Autoneg: On, Link:Up.
Initial DNS resolving preference is ipv4-only
Downloading 'ftp://*:*@192.254.173.5/tmp/dxp/dxp2537.cfg'...OK
Sap Index file location: ftp://*:*@192.254.173.5/tmp/dxp/dxp2537.sdx
Downloading 'ftp://*:*@192.254.173.5/tmp/dxp/dxp2537.sdx'...OK
Primary image location: ftp://*:*@192.254.173.17/usr/global/images/20.3/B1-1/7xxx/
bcmiproc-both.tim
Port 1/1/1-->Mode:Fix-Cu, Speed:100, Duplex:Full Autoneg: On, Link:Up.
Initial DNS resolving preference is ipv4-only
3HE 17358 AAAB TQZZA
console output is displayed.
following console output is displayed.
primary-image
ftp://*:*@192.254.173.17/usr/global/images/20.3/B1-1/7xxx/
primary-config
ftp://*:*@192.254.173.5/tmp/dxp/dxp2537.cfg
uplinkA-port
1/1/1
uplinkA-autoneg
uplinkA-duplex
full
uplinkA-speed
1000
uplinkA-address
10.135.25.37/24
uplinkA-vlan
null
uplinkA-route
192.0.0.0/8 next-hop 10.135.25.1
uplinkB-port
1/1/12
no
uplinkB-autoneg
uplinkB-duplex
full
uplinkB-speed
10000
uplinkB-address
0
uplinkB-vlan
0
wait
3
persist
off
console-speed
115200
uplink-mode
access-uplink
no
console-disabled
The following console output is displayed.
Use subject to Terms available at: www.nokia.com
or 'disable' to disable console access
© 2021 Nokia.
Appendix: 7210 SAS Boot Procedures
699

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7210 sas-mxp7210 r67210 r127210 s7210 sx7210 t

Table of Contents