Nokia 7210 Configuration Manual page 705

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Step 21. At the prompt, enter disable to proceed with no backup link. The following
Existing uplinkB port settings are:
Step 22. At the prompt, enter disable to proceed with no backup link. The following
Current configuration enables use of console (setting is "no console-disabled")
Press ENTER to proceed with existing setting
:
Step 23. At the prompt, press Enter. The following console output is displayed.
New Settings
------------
#eth-mgmt Port Settings:
#uplinkA Port Settings:
3HE 17358 AAAB TQZZA
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-address 0
uplinkA-vlan 0
uplinkA port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
console output is displayed.
uplinkB-port 1/1/66
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 100000
uplinkB-address 0
uplinkB-address 0
uplinkB-vlan 0
uplinkB port is configured for Boot Interface Management,
Press ENTER to proceed with existing port settings
Or "disable" to disable the port for Boot Interface Management
Or "edit" to change the port settings:
console output is displayed.
primary-image ftp://*:*@192.254.173.3/tmp/sass/b/both.tim
primary-config ftp://*:*@192.254.173.3/tmp/sass/sassx64.cfg
no eth-mgmt-disabled
eth-mgmt-address 10.135.25.36/24 active
eth-mgmt-route 10.135.0.0/16 next-hop 10.135.25.1
eth-mgmt-route 192.0.0.0/8 next-hop 10.135.25.1
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
uplinkA-port 1/1/65
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-vlan 0
Use subject to Terms available at: www.nokia.com
or 'disable' to disable console access
© 2021 Nokia.
Appendix: 7210 SAS Boot Procedures
705