Nokia 7210 Configuration Manual page 502

System Management
Description This command specifies the interval that the standby node will wait for packets from the active
node before assuming a redundant-neighbor node failure. This delay in switch-over operation
is required to accommodate different factors influencing node failure detection rate, such as
IGP convergence, or HA switch-over times and to prevent the standby node to take action
prematurely.
The no form of this command reverts to the default value.
Default 3
Parameters multiplier — Specifies the time interval that the standby node will wait for packets from
keep-alive-interval
Syntax keep-alive-interval interval
no keep-alive-interval
Context config>redundancy>multi-chassis>peer>mc-lag
Platforms Supported on all 7210 SAS platforms as described in this document
Description This command sets the interval at which keep-alive messages are exchanged between two
systems participating in MC-LAG. These keep-alive messages are used to determine
remote-node failure and the interval is set in deciseconds.
The no form of this command reverts to the default value.
Default 1s (10 hundreds of milliseconds means interval value of 10)
Parameters interval — Specifies the time interval expressed in deciseconds.
lag
Syntax lag lag-id lacp-key admin-key system-id system-id [remote-lag remote-lag-id] system-
lag lag-id [remote-lag remote-lag-id]
no lag lag-id
Context config>redundancy>multi-chassis>peer>mc-lag
Platforms Supported on all 7210 SAS platforms as described in this document
502
the active node before assuming a redundant-neighbor node failure.
Values 2 to 25
Values 5 to 500
priority system-priority
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA