Nokia 7210 Configuration Manual page 239

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
========================================================================
#System Settings:
=======================================================================
Step 14. After the IMM-only BOF parameters are configured, save the BOF by
Step 15. Take note of the MAC address of the node chosen as the IMM-only node.
Step 16. At the TiMOS prompt on the active CPM node, proceed with the VC
When the VC configuration information has been committed in the CLI, the active
CPM node sends the VC configuration to all other nodes in the VC through VC
management messages over the stacking ports.
When the IMM-only nodes receive the VC management messages from the active
CPM, they confirm the VC configuration by matching their chassis address to the
MAC address contained in the VC message.They then retrieve the TiMOS image
from the active CPM and use it to boot up.
While booting up with the TiMOS image, the standby CPM node undergoes another
CPM election arbitration process, which results in the node detecting itself as
standby. The node then executes the HA reconcile process and synchronizes its
management and control plane state with the active CPM. It receives the current
running configuration with the VC configuration and the current BOF configuration
present on the active CPM.
The VC is now ready for use.
3HE 17358 AAAB TQZZA
wait 3
persist off
console-speed 115200
no console-disabled
vc-stack-node-type imm-only
typing Yes when prompted to save the BOF. Let the boot loader proceed
with the boot process.
The IMM-only node waits to receive VC configuration information from the
active CPM-IMM node.
The MAC address is the chassis MAC address printed on the label of the
node.
configuration by using the config>system>vc-stack>vc-stack-node
command to configure the IMM-only node slot number and MAC address.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
Virtual Chassis
239