Nokia 7210 Configuration Manual page 430

System Management
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), and 7210 SAS-T (network and access-uplink)
Description This command configures the PTP Announce interval.
The no form of this command reverts to the default value.
Default log-anno-interval 1
Parameters log-interval — Specifies the PTP Announce interval, specified as the logarithm to the
log-sync-interval
Syntax log-sync-interval values
no log-sync-interval
Context config>system>ptp
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), and 7210 SAS-T (network and access-uplink)
Description This command configures the message interval used for transmission of multicast
synchronization messages.
This command applies only if the profile is set to ieee1588-2008 or g8265dot1-2010. It does
not apply when g8275dot1-2014 is configured. When the profile is set to g8275dot1-2014,
the value is set to –4 (16 packets/s) and cannot be changed.
For multicast messages used on PTP Ethernet ports, this command configures the message
interval used for synchronization messages transmitted by the local node when the port is in
the master state.
The no form of this command reverts the message interval to the default value.
Default –6 (64 packets/s) for ieee1588-2008
–6 (64 packets/s) for g8265dot1-2010
–4 (16 packets/s) for g8275dot1-2014
Parameters values — Specifies the message interval, in log form.
430
base 2, in seconds.
Values –3 to 4, where –3 = 0.125 s, –2 = 0.25 s, –1 = 0.5 s, 0 = 1 s, 1 = 2 s,
2 = 4 s, 3 = 8 s, 4 = 16 s
Values –6 to –3, where –6 = 64 packets/s, –5 = 32 packets/s, –4 = 16
packets/s, –3 = 8 packets/s
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA