Nokia 7210 Configuration Manual page 656

System Management
sync-if-timing
Syntax sync-if-timing
Context show>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode; not supported on 7210 SAS platforms
configured in the standalone-VC operating mode
Description This command displays synchronous interface timing information.
Output The following outputs are examples of synchronous interface timing information, and
Table 90
Sample Output for 7210 SAS-M
The following is a sample output for a node locked to the active BITS input and directing the
signal on ref1 to the BITS output.
*A:MTU>show>system# sync-if-timing
===============================================================================
System Interface Timing Operational Info
===============================================================================
System Status CPM A
Reference Order
Reference Input 1
Reference Input 2
656
describes the output fields.
• Sample Output for 7210 SAS-M
• Sample Output for 7210 SAS-R6 and 7210 SAS-R12
• Sample Output for 7210 SAS-T and 7210 SAS-Mxp
• Sample Output for 7210 SAS-Sx/S 1/10GE
• Sample Output for 7210 SAS-Sx 10/100GE
Reference Input Mode
Quality Level Selection
Reference Selected
System Quality Level
Admin Status
Rx Quality Level
Quality Level Override
Qualified For Use
Not Qualified Due To
Selected For Use
Not Selected Due To
Source Port
Admin Status
Rx Quality Level
Quality Level Override
Qualified For Use
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
: Master Free Run
: Non-revertive
: Disabled
: none
: st3
: ref1 ref2
: down
: unknown
: none
: No
: disabled
: No
: disabled
: None
: down
: unknown
: none
: No
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA