Nokia 7210 Configuration Manual page 405

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
card
Syntax card card-id
Context config>system>vwm-shelf
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-T (network and access-uplink),
7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description Commands in this context provision the information for the modules that can be plugged into
the slots on the 1830 VWM clip-on device.
This command provides the user better control over the modules plugged into the 1830
CWDM device slots. The user can preprovision acceptable modules by configuring the card-
type parameter with the appropriate vwm-acronym. Modules are identified using the card type
acronyms listed in
The no form of this command removes the configured card ID and the software forgets all the
information it has for the card. The software will not raise any events/traps/alarms for the card
and clear all pending events/traps/alarms/LEDs.
Parameters card-id — Specifies the card on the 1830 VWM clip-on device attached to 7210 SAS.
shutdown
Syntax [no] shutdown
Context config>system>vwm-shelf
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-T (network and access-uplink),
7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description This command administratively disables the management of the clip-on device identified by
the parameter vwm-shelf-id. When this command is executed, the software will clear all
pending events/traps/alarms related to this shelf.
The no form of this command administratively enables the management of the clip-on device.
The software raises appropriate events/traps/alarms for the device.
Default no shutdown
card-type
Syntax [no] card-type card-type
3HE 17358 AAAB TQZZA
Table 42
Card ID 1 identifies the module in slot #1 of the 1830 CWDM device and Card ID 2
identifies the module in slot #2 of the 1830 CWDM device.
Values 1, 2
Use subject to Terms available at: www.nokia.com
and Table 43.
© 2021 Nokia.
System Management
405