Nokia 7210 Configuration Manual page 662

System Management
Table 90
script-control
Syntax script-control
Context show>system
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description Commands in this context display script information.
script
Syntax script [script-name] [owner script-owner]
662
Output Fields: Sync Interface Timing (Continued)
Label
Framing
Line Coding
Line Length
Output Admin Status
Output Reference
Selected
TX Quality Level
Quality Level Selection
System Quality Level
Rx Quality Level
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Description (Continued)
The framing configured for the BITS port
The line coding configured for the BITS port
The line length value of the BITS output
down — The BITS output is administratively shutdown
up — The BITS output is administratively enabled
diag — Indicates the BITS output has been forced using the
force-reference command
The reference selected as the source for the BITS output signal
(ref1 or ref2)
QL value for BITS output signal
Indicates whether the ql-selection command has been enabled
or disabled
If this command is enabled, the reference is selected first using
the QL value, then by the priority reference order. If this
command is not enabled, the reference is selected by the priority
reference order.
Indicates the quality level being generated by the system clock
Indicates the QL value received on the interface
inv — SSM received on the interface indicates an invalid code for
the interface type
unknown — No QL value was received on the interface
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA