System Management
ALA-1>admin# disconnect
ALA-1>admin# Logged out by the administrator
Connection to host lost.
C:\>
6.11.4.4
Use the set-time command to set the system date and time. The time entered should
be accurate for the time zone configured for the system. The system will convert the
local time to UTC before saving to the system clock, which is always set to UTC. If
SNTP or NTP is enabled (no shutdown), this command cannot be used. The set-
time command does not take into account any daylight saving offset, if defined.
Use the following syntax to set the date and time.
CLI Syntax:
The following example shows the command usage to set the date and time.
Example:
The following is a sample output of the set-time command.
ALA-2# admin set-time 2007/02/06 04:10:00
ALA-2# show time
Thu Feb 2 04:10:04 GMT 2007
ALA-2#
6.11.4.5
The display-config command displays the running configuration of the system.
Use the following syntax to display the running configuration of the system.
CLI Syntax:
The following example shows the command usage to display the running
configuration of the system.
Example:
348
Set-time
admin
set-time date time
admin# set-time 2007/02/06 04:10:00
Display-config
admin
display-config [detail] [index]
admin# display-config detail
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA