Nokia 7210 Configuration Manual page 554

System Management
However, the default single slice of entries is not sufficient if all IP and MPLS control-plane
protocols are enabled simultaneously. To allocate an additional slice to IP and MPLS
protocols, use this command to set the value of num-resources to 2.
Note: The software allocates protocol entries when the protocol is enabled and deallocates
the protocol entries when the protocol (and all instances of the protocol, if any) is disabled.
See the relevant CLI command descriptions for more information about resource allocation
for specific protocols. To display information about the utilization of resources allocated to
IP and MPLS protocols, use the tools>dump>system-resources CLI command.
The no form of this command reverts to the default value.
Default ip-mpls-protocols 1
Parameters num-resources — Specifies the number of slices to be allocated for IP and MPLS control-
qos-access-port-ingress-resource
Syntax qos-access-port-ingress-resource num-resources
no qos-access-port-ingress-resource
Context configure>system>res-profile>ing-internal-tcam
Platforms 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx/S 1/10GE (standalone), and
7210 SAS-Sx 10/100GE (standalone)
Description
Note: This command is not supported on a 7210 SAS-R6 equipped with the IMMv1 card.
This command allocates ingress internal TCAM resources to access-ingress port policies
when the access port is configured in port mode. If adequate TCAM resources are not
allocated, setting the access-ingress-qos-mode command to port-mode is not allowed.
If access ports are currently configured to use a port-based access ingress QoS policy,
setting the qos-access-port-ingress-resource command to 0 (which will set the number of
resources allocated to the access port ingress QoS policy to 0) is not allowed. Resources
allocated to access ingress QoS policies are used to allocate meter resources for the port-
based access ingress QoS policy.
554
plane protocols.
Values 1, 2
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA