Nokia 7210 Configuration Manual page 708

Appendix: 7210 SAS Boot Procedures
main
TiMOS BOOT LOADER
Time from clock is WED MAR 04 11:18:16 2020 UTC
Switching serial output to sync mode...
Chassis-role is set to : standalone
Looking for uf1:/bof.cfg ... OK, reading
Step 2. The system locates the BOF on a local drive. The system reads the
Contents of Boot Options File on uf1:
#eth-mgmt Port Settings:
#uplinkA Port Settings:
#uplinkB Port Settings:
#System Settings:
Hit a key within 1 second to change boot parameters...
Step 3. At the prompt, wait until the specified wait time has elapsed. The boot
Configuring Network with uplinkA Port Setting.....
No existing config file URL
Primary image location: uf1:\both.tim
Loading image uf1:\both.tim
Version B-20.3.B1-1, Wed Feb 12 15:33:08 IST 2020 by sasbuild in /home/sasbuild/
20.3B1/panos/main
text:(41664192-->183719312) + data:(7133216-->49945144)
Executing TiMOS image at 0x2800000
708
contents of the BOF and displays it on the console.
The following console output is displayed.
primary-image uf1:\both.tim
eth-mgmt-disabled
uplinkA-port 1/1/67
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-vlan 0
uplinkB-port 1/1/68
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 100000
uplinkB-address 0
uplinkB-vlan 0
wait 3
persist off
console-speed 115200
no console-disabled
process can be interrupted at the prompt if necessary to change the boot
parameters (for example, the image location). In this example, it is
assumed that changes to the BOF are not required.
The following console output is displayed.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
done
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA