Nokia 7210 Configuration Manual page 539

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
ipv4-mac-match-enable
Syntax ipv4-mac-match-enable num-resources
no ipv4-mac-match-enable
Context configure>system>resource-profile>ingress-internal-tcam>qos-sap-ingress-resource
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates maximum resources for use by SAP ingress QoS policies using both
MAC (any) and IPv4 criteria (any) criteria in a policy.
The available resources is used by software to allocate resources for SAP ingress policies
using the following criteria - either both IPv4 criteria any and MAC criteria any, only mac
criteria any, only ipv4 criteria, dot1p-only criteria, ipv4 dscp-only criteria and ipv6 dscp-only
criteria. It is not used for SAP ingress policies that use ipv6 criteria any.
Refer to the 7210 SAS-M, T, R6, R12, Mxp, Sx, S Quality of Service Guide for more
information on resource allocation.
The no form of this command specifies that the software does not allocate any resources for
use by SAP ingress QoS policies using both MAC and IPv4 criteria. If no resources are
allocated for use, then software fails all attempts to associate a service entity (for example,
SAP and IP interface) with an ingress filter policy or SAP ingress QoS policy using this match
criteria.
3HE 17358 AAAB TQZZA
If the user specifies max, the software allocates one chunk when the first SAP is
associated with an ingress filter policy using this match criteria. It continues to
allocate resources to SAPs associated with an ingress filter policy using this criteria,
provided that the total amount of resources allocated does not exceed the resources
allocated to qos-sap-ingress-qos resource pool (configured with the config system
resource-profile ingress-internal-tcam qos-sap-ingress-resource command)
and chunks are available for use.
Values 0 to 10, max (7210 SAS-Mxp)
0 to 12, max (7210 SAS-R6 and 7210 SAS-R12)
Default 0
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
539