Nokia 7210 Configuration Manual page 426

System Management
description description-string — Specifies a user configurable string that can be used to
owner owner — Specifies the creator of this alarm. This parameter is defined primarily
6.12.2.1.5
ptp
Syntax ptp
Context config>system
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), 7210 SAS-T (network and access-uplink)
Description Commands in this context configure parameters for IEEE 1588-2008, Precision Time
Protocol.
anno-rx-timeout
Syntax anno-rx-timeout count
no anno-rx-timeout
Context config>system>ptp
Platforms 7210 SAS-M (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12,
7210 SAS-Sx 1/10GE (standalone), 7210 SAS-T (network and access-uplink)
Description This command configures the PTP announce receipt timeout count in the Announce
message.
The no form of this command reverts the count to the default value.
426
both — Both an entry in the RMON-MIB logTable and a TiMOS
logger event are generated.
none — No action is taken.
Default both
identify the purpose of this event. This is an optional parameter and can be up to 80
characters. If the string contains special characters (#, $, spaces, and so on), the
entire string must be enclosed within double quotes.
to allow entries that have been created in the RMON-MIB alarmTable by remote
SNMP managers to be saved and reloaded in a CLI configuration file. The owner will
not normally be configured by CLI users and can be a maximum of 80 characters.
Default TiMOS CLI
PTP Commands
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA