Nokia 7210 Configuration Manual page 564

System Management
This command does not enable the use of IP ECMP. To enable IP ECMP, the user must use
the config router ecmp command. The number of routes specified using the config router
ecmp command cannot exceed the number of routes specified by this command, though it
can be lesser. If its lesser, the software will use only the specified number routes. Specifying
a lesser number of routes with config router ecmp will result in wastage of hardware
resources. To enable LDP ECMP, see the configure system resource-profile router ldp-
ecmp command.
Note:
Default 1
Parameters max-routes-dest — Specifies the number of ECMP routes.
ldp-ecmp
Syntax ldp-ecmp percent-value
no ldp-ecmp
Context configure>system>resource-profile>router
configure>system>global-res-profile>router
Platforms Supported on all 7210 SAS platforms as described in this document
Description
Note: The configure>system>resource-profile context is supported on the 7210 SAS-M,
7210 SAS-T, 7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE: standalone, and 7210 SAS-Sx 10/
100GE.
The configure>system>global-res-profile context is supported on the 7210 SAS-R6,
7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC.
This command enables LDP ECMP and configures the percentage of the total amount of
hardware ECMP resources to be allocated for use by LDP ECMP FECs.
The remaining amount of resources are allocated for use by IP ECMP. In other words, the
hardware ECMP resources are shared by IP ECMP and LDP ECMP and this command allow
user to allocate resources to them.
564
• This command is a boot-time parameter and any change will take effect only after a
reboot.
• On 7210 SAS-R6 and 7210 SAS-R12, the value specified with this command is used
across all IMMs in the chassis.
Values 1 to 16
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA