Nokia 7210 Configuration Manual page 175

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Note:
The platforms can be operated in two modes of operations: satellite mode and
standalone mode.
Figure 21
variant.
Figure 21
Figure 22
variant.
3HE 17358 AAAB TQZZA
• Before using a 1GE SFP in an SFP+ port, the SFP+ port speed must be set to
1000 Mb/s with the config>port>ethernet>speed command; otherwise, an error
message is generated indicating that the SFP is unsupported. For information about
setting the port speed, refer to the Ethernet Port Commands section of the
7210 SAS-M, T, R6, R12, Mxp, Sx, S Interface Configuration Guide.
• SFP+ ports that support SFPs do not support speeds of 10 Mb/s or 100 Mb/s.
• On the 7210 SAS-Sx 10/100GE 64SFP+ 4CFP4 variant, ports on the front panel are
named 1/1/1 to 1/1/64 for the 64 SFP+ ports, and 1/1/65 to 1/1/68 for the four 100GE
CFP4 ports.
• On the 7210 SAS-Sx 10/100GE 64SFP+ 4QSFP28 variant, ports on the front panel are
named 1/1/1 to 1/1/64 for the 64 SFP+ ports, and 1/1/c1, 1/1/c2, 1/1/c3, and 1/1/c4 for
the four100GE QSFP28 ports.
• In satellite mode, it provides port expansion function and the platform is
managed by the 7x50 host. It does not need to be assigned an IP address. User
needs to connect the right ports to the 7x50 and power on the node. The node
automatically fetches the BOF, the image and the configuration required to
operate in satellite mode.
• In standalone mode, the platform provides IP/MPLS functionality and needs to
be an IP address and managed independently.
shows the front panel for the 7210 SAS-Sx 10/100GE 64SFP+ 4CFP4
Front Panel: 7210 SAS-Sx 10/100GE 64SFP+ 4CFP4
shows the front panel for the 7210 SAS-Sx 10/100GE 64SFP+ 4QSFP28
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
Boot Options
hw0743
175