Nokia 7210 Configuration Manual page 691

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Built on Wed Feb 12 15:31:09 IST 2020 by sasbuild in /home/sasbuild/20.3B1/panos/
main
TiMOS BOOT LOADER
Time from clock is SUN MAR 15 15:19:08 2020 UTC
Switching serial output to sync mode...
Chassis-role is set to : factory-default
Step 2. The system lists the default settings and the following console output is
Looking for cf1:/bof.cfg ... OK, reading
Contents of Boot Options File on cf1:
#eth-mgmt Port Settings:
#uplinkA Port Settings:
#uplinkB Port Settings:
#System Settings:
Hit a key within 3 seconds to change boot parameters...
Step 3. At the prompt, press any key to initiate boot parameter updates.
Enter password to edit the Boot Options File
Or CTRL-D to exit the prompt
Waiting for 30 seconds to enter password
Password:
Step 4. At the prompt, enter the default password password, and initiate the BOF
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
"diag" - enter the diag shell.
"reset" - reset the bof and reboot.
3HE 17358 AAAB TQZZA
displayed.
eth-mgmt-disabled
uplinkA-port 1/1/65
no uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 100000
uplinkA-address 0
uplinkA-vlan 0
uplinkB-port 1/1/66
no uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 100000
uplinkB-address 0
uplinkB-vlan 0
wait 3
persist off
console-speed 115200
no console-disabled
The following console output is displayed.
edit.
The system accepts the password and the following console output is
displayed.
Use subject to Terms available at: www.nokia.com
done
© 2021 Nokia.
Appendix: 7210 SAS Boot Procedures
691