Nokia 7210 Configuration Manual page 716

Appendix: 7210 SAS Boot Procedures
Waiting for 30 seconds to enter password
Password:
Step 5. At the prompt, enter the default password password, and initiate the BOF
You must supply some required Boot Options. At any prompt, you can type:
"restart" - restart the query mode.
"reboot" - reboot.
"exit" - boot with with existing values.
"diag" - enter the diag shell.
"reset" - reset the bof and reboot.
Press ENTER to begin, or 'flash' to enter firmware update...
Step 6. At the prompt, press Enter to edit the BOF. The following console output is
Chassis-Role
-------------
Current chassis-role is : standalone
You can change it to { satellite | standalone-vc | factory-default }.
Press ENTER to continue OR "edit" to change the chassis-role : standalone-vc
Press "edit" to change OR ENTER to continue :
Step 7. At the prompt, enter edit. The following console output is displayed.
Enter the new chassis-role { satellite | standalone-vc | factory-
default } :
Step 8. At the prompt, enter standalone-vc for the chassis-role. The following
Are you sure you want to set the chassis-role as standalone-vc? (yes/no) :
Step 9. At the prompt, enter yes. The following console output is displayed.
Looking for cf1:/bof.cfg ... OK, reading
Contents of Boot Options File on cf1:
#eth-mgmt Port Settings:
#System Settings:
Hit a key within 2 seconds to change boot parameters...
716
edit.
The system accepts the password and the following console output is
displayed.
displayed.
output is displayed.
no eth-mgmt-disabled
eth-mgmt-autoneg
eth-mgmt-duplex full
eth-mgmt-speed 100
wait 3
persist off
console-speed 115200
no console-disabled
vc-stack-node-type imm-only
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA