Nokia 7210 Configuration Manual page 77

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
ipv6
Syntax ipv6 ipv6-filter-id entry entry-id [interval seconds] [repeat repeat] [absolute | rate]
Context monitor>filter
monitor>management-access-filter
Platforms Supported on all 7210 SAS platforms as described in this document, including those
operating in access-uplink mode
Description This command enables IPv6 filter monitoring. The statistical information for the specified IPv6
filter entry displays at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified IPv6 filter. The
subsequent statistical information listed for each interval is displayed as a delta to the
previous display.
When the keyword rate is specified, the rate per second for each statistic is displayed instead
of the delta.
Monitor commands are similar to show commands but only statistical information displays.
Monitor commands display the selected statistics according to the configured number of
times at the interval specified.
Parameters iv6p-filter-id — Displays detailed information for the specified IPv6 filter ID and its filter
entry entry-id — Displays information on the specified IPv6 filter entry ID for the specified
interval seconds — Specifies the interval for each display in seconds.
repeat repeat — Specifies how many times the command is repeated.
absolute — Keyword to display the raw statistics, without processing. No calculations
rate — Keyword to display the rate per second for each statistic instead of the delta.
Output The following output is an example of IPv6 filter statistics.
Sample Output
*A:7210SAS>monitor>filter# ipv6 10 entry 10 interval 3 repeat 3 absolute
3HE 17358 AAAB TQZZA
entries.
Values 1 to 65535
filter ID only.
Values 1 to 65535
Default 10 seconds
Values 3 to 60
Default 10
Values 1 to 999
are performed on the delta or rate statistics.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
CLI Usage
77