Nokia 7210 Configuration Manual page 475

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
6.12.2.1.8
shutdown
Syntax [no] shutdown
Context config>system>time>sntp
config>system>lldp
config>system>sync-if-timing>ptp
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description
Note: The config>system>sync-if-timing>ptp context is not supported on
7210 SAS-Sx 10/100GE-Sx 10/100GE and 7210 SAS-S 1/10GE platforms.
This command administratively disables an entity. When disabled, an entity does not change,
reset, or remove any configuration settings or statistics.
The operational state of the entity is disabled as well as the operational state of any entities
contained within. Many objects must be shut down before they may be deleted.
The no form of this command administratively enables an entity.
Unlike other commands and parameters where the default state is not indicated in the
configuration file, the shutdown and no shutdown states are always indicated in system
generated configuration files.
The no form of this command places an entity in an administratively enabled state.
description
Syntax description description-string
no description
Context config>system>time>sntp
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description The command creates a string that can be used to identify the purpose of this event. This is
an optional parameter and can be 80 characters. If the string contains special characters (#,
$, spaces, and so on), the entire string must be enclosed within double quotes.
3HE 17358 AAAB TQZZA
Generic Commands
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
475