Nokia 7210 Configuration Manual page 556

System Management
Note:
The no form of this command reverts to the default value.
Default qos-network-ingress-resource 0
Parameters num-resources — Specifies the number of resources allocated to network ingress QoS
qos-sap-ingress-resource
Syntax qos-sap-ingress-resource num-resources
no qos-sap-ingress-resource
Context configure>system>resource-profile>ing-internal-tcam
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description This command allocates maximum resources for use by SAP ingress QoS policies using any
of the supported match criteria. This command limits the total amount of chunks allocated for
use by SAP ingress QoS policies to the value specified by num-resources. That is, the
cumulative sum of chunks allocated to different match criteria supported by SAP ingress QoS
policies cannot exceed the value configured with num-resources.
Note: On the 7210 SAS-Sx 10/100GE, the sum of resources, also called slices, allocated
to SAP ingress policies using the config>system>resource-profile>ingress-internal-
tcam>qos-sap-ingress-resource command and to access ingress policies using the
config>system>resource-profile>ingress-internal-tcam>qos-access-port-ingress-
resource command must not exceed 3.
556
• The minimum num-resources configurable is 0 and the maximum num-resources
configurable is 2. The default num-resources is 2 for the default system resource
profile and user-configured system resource profile. A value of 1 is not allowed.
• If the user configures the value 2, one slice is allocated to the network QoS policy IP
interface, and one slice is allocated to the network QoS policy port.
• A reboot is not required after assigning a new value to the qos-network-ingress-
resource command. That is, the value of this command can be changed from 0 to 2 if
there are resources available in the ingress-internal-tcam pool. Similarly, the value can
be changed from 2 to 0 if no network or hybrid ports are configured. If a network port
or hybrid port is configured, changing the value from 2 to 0 is fails and the system
sends an error message.
policy queues.
Values 0, 2, def
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
3HE 17358 AAAB TQZZA