Nokia 7210 Configuration Manual page 551

Service access switch 7210 sas-m, t, r6, r12, mxp, sx, s basic system
Hide thumbs Also See for 7210:
Table of Contents

Advertisement

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Note: On the 7210 SAS-Sx/S 1/10GE operating in standalone-VC mode, bidirectional MIPs
configured on Epipe SAPs and Epipe SDP bindings also require resources from the Up
MEP resource pool.
The no form of this command removes resources for Down MEPs on SDPs, ingress MIPs,
and bidirectional MIPs.
Default
sdp-down-mep-ing-mip 1
Parameters
num-resources — Specifies the maximum amount of resources for use by Down MEPs
up-mep
Syntax
up-mep num-resources
no up-mep
Context
configure>system>resource-profile>ingress-internal-tcam>eth-cfm
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description
This command allocates resources for CFM Up MEPs.
Resources for Up MEPs created on SAPs and SDP bindings are allocated from this pool.
Note:
The no form of this command specifies that the software does not allocate any resources for
use by CFM Up MEPs. If no resources are allocated for use, the software fails all attempts to
configure an Up MEP and bidirectional MIPs on applicable platforms (see preceding Note:).
Default
up-mep 0
3HE 17358 AAAB TQZZA
on SDPs and ingress MIPs.
Values
1 to 2
• On the 7210 SAS-R6 and 7210 SAS-R12, when an Up MEP on an SDP binding is
created, resources are allocated for the Up MEP on all IMMs, and when an Up MEP
on a SAP is created, resources are allocated only on the IMM for which the SAP is
configured or on the set of IMMs if the SAP is configured over a LAG.
• On the 7210 SAS-R6 and 7210 SAS-R12, resources from this pool are used only for
Up MEPs configured in Epipe services. Up MEPs configured in a VPLS service use
resources from a different pool.
• On the 7210 SAS-R6 and 7210 SAS-R12, and on the 7210 SAS-Sx/S 1/10GE
operating in standalone-VC mode, resources from this pool are also used for
bidirectional MIPs configured on Epipe SAPs and Epipe SDP bindings.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
551

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

7210 sas-mxp7210 r67210 r127210 s7210 sx7210 t

Table of Contents