Nokia 7210 Configuration Manual page 712

Appendix: 7210 SAS Boot Procedures
*A:dut-h# show system satellite
===============================================================================
Satellite Information
===============================================================================
SatID
-------------------------------------------------------------------------------
esat-1
-------------------------------------------------------------------------------
No. of Satellites: 1
===============================================================================
*A:dut-h#
Step 4. Power on the Ethernet satellite.
*A:dut-h# show system satellite
===============================================================================
Satellite Information
===============================================================================
SatID
-------------------------------------------------------------------------------
esat-1
-------------------------------------------------------------------------------
No. of Satellites: 1
===============================================================================
*A:dut-h#
712
iii. Issue the show system satellite command to display the status of the
satellite. The following output is displayed.
Provisioned Type
Equipped Type (if different)
es64-10gb-sfpp+4-100gb-qsfp28
(not equipped)
i. Power on the 7210 SAS device.
The satellite will use the bootloader on the SD card inserted in cf2:\ (SD
card slot on the rear of the chassis) and initiate the boot procedure.
The 7210 SAS device sends DHCP requests out of its uplink ports.
The 7750 SR host uses the MAC address in the received packets and
matches it against MAC addresses provided in the Ethernet satellite
configuration on the 7750 SR host.
After finding a match, the 7750 SR host uses the configured image and
an appropriate configuration file, generates a BOF, and sends it to the
system (the host-type parameter in the BOF generated by the 7750 SR
host is set to satellite).
The 7210 SAS boot loader uses the BOF to retrieve the images and the
configuration file, and uses them to boot the platform in the satellite
mode (because the host-type is set to satellite).
The satellite transitions through the following states: provisioned,
booting, and up.
ii. Issue the show system satellite command to determine the boot
status of the satellite. The following output is displayed.
Provisioned Type
Equipped Type (if different)
es64-10gb-sfpp+4-100gb-qsfp28
(not equipped)
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Admin
State
up
Admin
State
up
Configuration Guide
Oper
State
provisioned
Oper
State
provisioned
3HE 17358 AAAB TQZZA