7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
Broadcast-client
The broadcast-client command enables listening at the global device level to SNTP
broadcast messages on interfaces with broadcast client enabled.
Use the following CLI syntax to enable listening to SNTP broadcast messages at the
global device level.
CLI Syntax:
The following example shows the command usage to enable listening to SNTP
broadcast messages at the global device level.
Example:
The following is a sample configuration output of SNTP enabled with the broadcast-
client command enabled.
A:ALA-12>config>system>time# info
----------------------------------------------
----------------------------------------------
A:ALA-12>config>system>time#
Server-address
The server-address command configures an SNTP server for SNTP unicast client
mode.
Use the following CLI syntax to configure an SNTP server for unicast client mode.
CLI Syntax:
3HE 17358 AAAB TQZZA
config>system>time>sntp
broadcast-client
config>system>time>sntp#
config>system>time>sntp# broadcast-client
config>system>time>sntp# no shutdown
sntp
broadcast-client
no shutdown
exit
dst-zone PT
start second sunday april 02:00
end first sunday october 02:00
offset 0
exit
zone GMT
config>system>time>sntp#
config>system>time>sntp# server-address ip-
address version version-number]
[normal|preferred] [interval seconds]
© 2021 Nokia.
Use subject to Terms available at: www.nokia.com
System Management
333