Nokia 7210 Configuration Manual page 156

Boot Options
2.0
#eth-mgmt Port Settings:
#uplinkA Port Settings:
uplinkA-port
#uplinkB Port Settings:
uplinkB-port
#System Settings:
===============================================================================
A:7210>show#
The following output is an example of configuration to enable satellite mode in the
BOF for the 7210 SAS-Sx/S 1/10GE.
===============================================================================
A:7210SAS-Sx# shell satclicmd 1 "show bof"
===============================================================================
BOF (Memory)
===============================================================================
#eth-mgmt Port Settings:
#uplinkA Port Settings:
#uplinkB Port Settings:
#System Settings:
156
primary-config tftp://xx.xxx.xx.xxx/MTU/mtu3DGP.cfg
eth-mgmt-disabled
1/1/1
uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 1000
uplinkA-address 0
uplinkA-vlan 0
1/1/2
uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 1000
uplinkB-address 0
uplinkB-vlan 0
wait 3
persist off
console-speed 115200
no console-disabled
primary-image ftp://*:*@xx.x.x.x/esat-1/primary/
secondary-image ftp://*:*@xx.x.x.x/esat-1/secondary/
tertiary-image ftp://*:*@xx.x.x.x/esat-1/tertiary/
primary-config ftp://*:*@xx.x.x.x/esat-1/config.cfg
eth-mgmt-disabled
uplinkA-port 1/1/49
uplinkA-autoneg
uplinkA-duplex full
uplinkA-speed 1000
uplinkA-address xx.xxx.x.x/19
uplinkA-vlan 0
uplinkA-route xx.x.x.x/32 next-hop xx.xxx.x.x
uplinkB-port 1/1/50
uplinkB-autoneg
uplinkB-duplex full
uplinkB-speed 1000
uplinkB-address xx.xxx.x.x/19
uplinkB-vlan 0
uplinkB-route xx.x.x.x/32 next-hop xx.xxx.x.x
wait 3
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
© 2021 Nokia.
Configuration Guide
/S80/MTU-sultan/
3HE 17358 AAAB TQZZA