System Management
The no form of this command specifies that the software does not allocate any resources for
use by egress filter policies using ipv6 criteria with 128-bit IPv6 addresses. If no resources
are allocated for use, the software fails all attempts to associate a service entity (for example,
SAP and IP interface) with a filter policy using this match criteria.
Default
no ipv6-128bit-match-enable
Parameters
num-resources — Specifies the maximum amount of resources for use by this filter
Table 45
mac-ipv4-match-enable
Syntax
[no] mac-ipv4-match-enable num-resources
Context
configure>system>resource-profile>egress-internal-tcam>acl-sap-egress
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
522
match criteria. A minimum value of 2 (indicating two chunks of resources) must be
allocated to use this match-criteria. If not, association of a policy with ipv6-128bit
criteria to a SAP will fail. It is mutually exclusive to use of SAP egress aggregate
meter.
Values
Table 45
Number of Resources Available for IPv6-128Bit-Match-Enable
Platforms
7210 SAS-M (per node)
7210 SAS-T access-uplink mode (per node)
7210 SAS-T network mode (per node)
7210 SAS-Sx 1/10GE (standalone)
7210 SAS-Sx 1/10GE (standalone-VC)
7210 SAS-S 1/10GE (standalone)
7210 SAS-S 1/10GE (standalone-VC)
7210 SAS-Sx 10/100GE
7210 SAS-Mxp
7210 SAS-R6 and 7210 SAS-R12
7210 SAS-R6 (per IMM)
Use subject to Terms available at: www.nokia.com
7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
lists the parameter values.
© 2021 Nokia.
Configuration Guide
Min value
Max value
(per node)
(per node)
0
2
0
2
0
2
0
2
0
2
0
2
0
2
0
2
0
2
0
2
0
0
3HE 17358 AAAB TQZZA
Default
Values
0
0
0
0
0
0
0
0
0
0
2