Nokia 7210 Configuration Manual page 517

7210 SAS-M, T, R6, R12, Mxp, Sx, S Basic System
Configuration Guide
port-range — Specifies the port, list of ports, a port range, or a combination of these that
egress-internal-tcam
Syntax egress-internal-tcam
Context configure>system>resource-profile
Platforms Supported on all 7210 SAS platforms as described in this document, including platforms
configured in the access-uplink operating mode
Description Commands in this context allocate resources from the egress internal TCAM pool.
The egress internal TCAM resource pool is shared by multiple features. The resources are
allocated to features in chunks of fixed size; multiple features cannot share the same chunk.
The users can allocate the available resources based on their feature scaling requirements.
The system allocates resources to the feature from its allocated chunk until the chunk runs
out of resources. The users can reallocate chunks of resources from features that do not
need to be enabled.
To free up the resources for use by one or more features, modify the configuration to release
the chunks of resources that are in use by other features. For example, to free up a chunk of
resources allocated to egress ACLs MAC criteria and allocate it to IP criteria, perform the
following steps.
To free up a chunk of resources used by egress ACLs and allocate it to the SAP egress
aggregate meter (on platforms that support this feature), perform the following steps.
3HE 17358 AAAB TQZZA
are being decommissioned when they appear on the left-hand side of the to keyword.
This parameter identifies the port or group of ports that receives the packet buffers
from the decommissioned ports. A group of ports can be specified as a list of ports
or as a range of ports.
The list of ports can be specified in any order using a comma to separate the list of
ports, while a port range must always be specified in the ascending order of port IDs
(in other words, the first port number specified in the range must be greater than the
second port number in the range) and a single range cannot refer to ports on different
MDA or different IMMs or different slots.
1. Remove the association of SAPs with egress ACLs that use a MAC criteria policy.
2. Change the resource profile configuration to allocate the chunk to IP criteria.
3. Create and associate the SAPs with the IP criteria.
1. Remove the association of SAPs with egress ACLs.
2. Change the resource profile configuration to reduce the chunk resources allocated to
egress ACLs (and reduce the value of chunks in use by the egress ACLs match criteria).
3. Allocate the chunk of resources to the SAP egress aggregate meter feature (on
platforms that support this feature).
4. Configure the SAPs with the aggregate meter rate.
Use subject to Terms available at: www.nokia.com
© 2021 Nokia.
System Management
517