Installing An Sms Modem - Huawei FusionModule2000 Installation Manual

FusionModule2000 Smart Modular Data Center
Installation Guide (2000 mm High Cabinets, Dual-Row
Aisle Containment, 208 V)
1.
2.
3.
When connecting the cables, mark the L (brown) and N (blue) wires to ensure correct
connection.
4.
Figure 11-17 Cable connections to aisle lights
(A) Light

11.8 Installing an SMS Modem

Prerequisites
An idle serial port is available on the server.
Context
Bind an SMS modem (BOM number: 50030084) to the rack rail at the rear of the network
cabinet near the server using cable ties.
Issue 01 (2017-07-30)
Connect lights in series, and connect the light near the AC actuator to the cable delivered
with the light. Here, the female connector is used as an example, as shown by (1) in
Figure 11-17.
Cut off the connector at the other end of the cable delivered with the light, strip the
insulation layer from the cut end, and route the cable out of the aisle containment, as
shown by (2) in Figure
The cable outlets for aisle lights are on the outermost skylight plate.
Connect the cut end to the multi-cord end terminal onsite, as shown by (3) in
11-17.
Route the other end of the connected cable (as shown by B in
cable trough to obtain power from the AC actuator.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
11-17.
(B) To the AC actuator
11 Cable Routing
Figure
Figure 11-17) through the
195