Installing A Fingerprint And Card Reader With A Keypad - Huawei FusionModule2000 Installation Manual

FusionModule2000 Smart Modular Data Center
Installation Guide (2000 mm High Cabinets, Dual-Row
Aisle Containment, 208 V)
Figure 8-45 Installing a fingerprint and card reader
Step 2 Secure the baffle plate with the cable hole in the lower part to the pad mounting kit using the
M4 nuts, spring washers, and flat washers, as shown by (2) in
Step 3 Remove the M2.5 screws (set aside) of the fingerprint and card reader and take off the
baseplate, as shown by (3) and (4) in
Step 4 Secure the baseplate to the baffle plate using two M3x8 countersunk screws, as shown by (5)
in Figure
Step 5 Route the fingerprint and card reader cable through the cable hole in the baffle plate, as shown
by (6) in
Step 6 Secure the fingerprint and card reader to the baseplate, as shown by (7) and (8) in
----End

8.8.8.2 Installing a Fingerprint and Card Reader with a Keypad

Context
The BOM number of a fingerprint and card reader with a keypad is 02070174.
Procedure
Step 1 Remove the M4 nuts, spring washers, and flat washers (set aside) from the baffle plate in the
target installation position and remove the baffle plate, as shown by (1) in
Issue 01 (2017-07-30)
Keep the protruding plane of the baffle plate flush with the end plane of the pad mounting kit.
8-45.
Figure 8-45.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 8-45.
8 Installing Monitoring Devices
Figure 8-45.
Figure
Figure 8-46.
8-45.
154