Configure Olt_A Cascading With Olt_B - Huawei SmartAX MA5603T Configuration Manual

SmartAX MA5600T/MA5603T/MA5608T Multi-service
Access Module
Commissioning and Configuration Guide

13.3.6.3 Configure OLT_A cascading with OLT_B

Prerequisites
Required hardware for OLT_A is ready.
l
l
l
l
Data Plan
Table 13-11
Table 13-11 Key data plan for OLT_A
Item
OPGD Port: 0/2/1
VLA
N ID
and IP
addres
s
Procedure
Step 1 Configure the management VLAN and IP address.
Create management VLAN 8, and set the management IP address to 192.168.50.30 and subnet
mask to 255.255.255.0.
huawei(config)#vlan 8 smart
huawei(config)#interface vlanif 8
huawei(config-if-vlanif8)#ip address 192.168.50.30 24
Step 2 Configure cascading with OLT_B.
Cascade OLT_A and OLT_B through GE port 0/2/1 on the OPGD board. Set the port attribute
to cascade, and add the cascading port to VLAN 300.
huawei(config)#interface opg 0/2
huawei(config-if-opg-0/2)#network-role cascade
huawei(config-if-opg-0/2)#quit
Issue 01 (2014-04-30)
Control board: SCUN+CKMC/CKMD
GPON service board: GPBD
Upstream board: EDTB
Cascaded service board:
– GE port: GICK or OPGD
– 10GE port: X2CS
provides the key data plan.
Data
In-band management
VLAN ID: 8
In-band management
IP address:
192.168.50.30/24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
13 FTTO Configuration (Large-sized Enterprise Access)
Remarks
Assume that OLT_A is cascaded with OLT_B using the
OPGD board. Then you need to set the network role of the
OPGD board to cascade.
To telnet to another OLT or ONU from the OLT and then
configure the OLT or ONU, you must configure the in-band
management VLANs and IP addresses of the OLT on the
OLT.
If the management IP address and the IP address of OLT_B
or ONU_B are not in the same network segment, you also
need to configure routes.
1347