Cisco ONS 15454 Hardware Installation Manual page 99

Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Warning
Use copper conductors only. Statement 1025
Warning
Connect the unit only to DC power source that complies with the safety extra-low voltage (SELV)
requirements in IEC 60950-1 based safety standards. Statement 1033
Warning
This product requires short-circuit (overcurrent) protection, to be provided as part of the building
installation. Install only in accordance with national and local wiring regulations. The short-circuit
(overcurrent) protection rating must not exceed 30A. Statement 1045
Warning A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
1022
Warning
This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Caution Always use the supplied ESD wristband when working with a powered ONS 15454. For detailed instructions
on how to wear the ESD wristband, refer to the
and Cisco ONS Platforms
Procedure
Step 1
Verify that the correct fuse and alarm panel is installed in the top mounting space:
• (ETSI only) Verify that the fuse rating does not exceed 30A.
• The fuse rating for ANSI chassis must not exceed 30A.
Step 2 Depending on your type of shelf, connect the office ground to the 15454 ETSI or the 15454 ANSI chassis.
For detailed instructions on grounding, refer to the
CPT and Cisco ONS Platforms
Step 3 Depending on your shelf, complete the
70 or the
Step 4 Complete the
Step 5
Continue with the
.
.
DLP-G18 Connect Office Power to the ONS 15454 ANSI, on page
DLP-G19 Turn On and Verify Office Power , on page
NTP-G8 Install the Fan-Tray Assembly , on page
Electrostatic Discharge and Grounding Guide for Cisco CPT
Electrostatic Discharge and Grounding Guide for Cisco
DLP-G17 Connect Office Power to the ONS 15454 ETSI , on page
Cisco ONS 15454 Hardware Installation Guide
NTP-G7 Install the Power and Ground
71.
74.
82.
69