Dlp-G309 Install The Ms-Isc-100T Card - Cisco ONS 15454 Hardware Installation Manual
Hide thumbs
Also See for ONS 15454:
- Troubleshooting manual (107 pages) ,
- Manual (88 pages) ,
- Procedure manual (62 pages)
Table of Contents
Advertisement
DLP-G309 Install the MS-ISC-100T Card
Step 2
Use the latches/ejectors to firmly slide the card along the guide rails in Slot 9 until the card plugs into the
receptacle at the back of the slot.
Step 3
Verify that the card is inserted correctly and close the latches/ejectors on the card.
Note
Step 4
Verify the following:
• The red FAIL LED blinks for up to 10 seconds.
Note
• The PWR A and PWR B LEDs become red, the two INPUT/OUTPUT LEDs become amber, and the
• The PWR A and PWR B LEDs turn green, the INPUT/OUTPUT LEDs turn off, and the green ACT LED
Note
Note
Note
Step 5
Return to your originating procedure (NTP).
DLP-G309 Install the MS-ISC-100T Card
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Note
When installing cards, allow each card to boot completely before installing the next card.
Cisco ONS 15454 Hardware Installation Guide
136
It is possible to close the latches/ejectors when the card is not completely plugged into the backplane.
Ensure that you cannot insert the card any further.
If the red FAIL LED does not turn on, check the power.
ACT LED turns green for approximately 5 seconds.
remains on.
It might take up to 3 minutes for the PWR A and PWR B LEDs to update.
If you insert a card into a slot provisioned for a different card, no LEDs turn on.
If the red FAIL LED is on continuously or the LEDs act erratically, the card is not installed properly.
Remove the card and repeat all the steps.
This task installs redundant MS-ISC-100T cards. The MS-ISC-100T card is
required for a multishelf node configuration. It provides LAN redundancy on the
node controller shelf. An alternative to using the MS-ISC-100T card is the Cisco
Catalyst 2950, although Cisco recommends using the MS-ISC-100T. For more
information on the Catalyst 2950 installation, refer to the Catalyst 2950 product
documentation.
MS-ISC-100T card (2)
DLP-G33 Install the TCC2, TCC2P, or TCC3 Card , on page 132
As needed
Onsite
None
Installing the ONS 15454 M12 (ANSI and ETSI) Shelf
Advertisement
Table of Contents
