Cisco ONS 15454 Hardware Installation Manual page 293
Hide thumbs
Also See for ONS 15454:
- Troubleshooting manual (107 pages) ,
- Manual (88 pages) ,
- Procedure manual (62 pages)
Table of Contents
Advertisement
Installing the ONS 15454 M2 Shelf
Security Level
Caution
Do not remove the TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O cards during the software installation process,
which is indicated by alternate flashing FAIL and ACT/STBY LEDs. Removing the
TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O cards during the software installation process will corrupt the
system memory.
Note
Allow each TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O card to boot completely before installing the redundant
TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O card.
Note
On the ONS 15454 M6 shelf, install the TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O cards in slots 1 and 8
for redundancy. On the ONS 15454 M2 shelf, install the stand-alone
TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O card in slot 1. For more information, see the
Requirements, on page
Note
You cannot insert the TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O cards in other slots due to mechanical
constraints. To identify the card slot, match the symbol placed on the lower side of the card front panel with
the symbol in the shelf.
Caution
To achieve redundancy, two TNC or TNCE cards or two TSC or TSCE cards must be installed in the ONS
15454 M6 shelf. Do not install one TNC or TNCE card and a redundant TSC or TSCE card in the same shelf.
Procedure
Step 1
Open the latches/ejectors of the first TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O card that you will install.
Step 2
Use the latches/ejectors to firmly slide the card horizontally along the guide rails until the card plugs into the
receptacle at the back of the slot (slot 1 or 8 in the ONS 15454 M6 shelf and slot 1 in the ONS 15454 M2
shelf).
Step 3
Verify that the card is inserted correctly, and close the latches/ejectors on the card.
If you insert a card into a slot assigned for a different card, all LEDs turn off.
Step 4
As needed, verify the LED activity on the TNC/TNCE/TSC/TSCE/TNCS-2/TNCS-2O card.
• The red FAIL LED, PWR LED turn on briefly.
• The red FAIL LED turns on for about 10 seconds.
• The red FAIL LED and the amber ACT/STBY LED turn on for about 30 seconds.
• The red FAIL LED blinks for about 10 seconds.
None
15.
DLP-G604 Install the TNC, TNCE, TSC, or TSCE Card
Cisco ONS 15454 Hardware Installation Guide
Card Slot
263
Advertisement
Table of Contents
