Cisco ONS 15454 Hardware Installation Manual page 38

Important Safety Recommendations
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
Warning
This unit is intended for installation in restricted access areas. A restricted access area can be accessed
only through the use of a special tool, lock and key, or other means of security. Statement 1017
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement
1022
Note The ONS 15454, ONS 15454 M2 and ONS 15454 M6 are suitable for mounting on concrete or other
noncombustible surfaces only.
Note In this chapter, "shelf" refers to the steel enclosure that holds cards and connects power, and "node" refers to
the entire hardware and software system.
Note
Unless otherwise specified, ONS 15454, ONS 15454 M2 and ONS 15454 M6 refers to both ANSI and ETSI
environments.
Note
The ONS 15454 M6 is suitable for installation in network telecommunication facilities where the National
Electric Code (NEC) applies.
Cisco ONS 15454 Hardware Installation Guide
8
Preparing to Install the ONS 15454 (ANSI and ETSI), ONS 15454 M2 and ONS 15454 M6 Shelf